CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reverse Brake Assembly
INSPECTION
• Inspect the drive plate facing for wear and damage.
• Check the driven plate for discoloration (burnt color).
• Check for worn snap ring, fatigue or damaged return spring or deformed spring retainer.
• Make sure the clearance between retaining plate and snap ring of reverse brake is within the limit. If it exceeds the limit, replace with a new drive plate and select and adjust the retaining plate within the initial standard value. Reverse Brake Assembly > ASSEMBLY">
Disassembly
InstallationStarting and stopping the engine (models without push-button start system)
CAUTION
When operating the Subaru Ascent starter motor, never crank the engine continuously
for more than 10 seconds.
If the engine of the Subaru Ascent does not start within 5 to 10 seconds,
stop cranking and wait at least 10 seconds before attempting again. This pause helps
prevent overh ...
Diagnostic procedure for subaru select monitor communication Communication for initializing impossible
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure for Subaru Select Monitor CommunicationCOMMUNICATION FOR INITIALIZING IMPOSSIBLEDIAGNOSIS:Open or short circuit in data link connectorTROUBLE SYMPTOM:Subaru Select Monitor communication failureWIRING DIAGRAM:Engine electrical system Engine Electr ...
Adjustment
VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)ADJUSTMENT1. VDC SENSOR MIDPOINT SETTING MODE (MODELS WITHOUT EyeSight)After installing, replacing or adjusting the following parts, perform the VDC sensor midpoint setting mode.• Steering angle se ...