CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed Sensor
INSPECTION
1. Set the ST between the TCM and bulkhead harness.
ST 18460AA040 | CHECK BOARD |
2. Set the probe of oscilloscope to the check board connector.
Connector & terminal
No. 14 (+) — No. 42 (−):
(A) | + probe |
(B) | − probe |
3. Start and warm up the engine.
4. Lift up the vehicle.
CAUTION:
Lift up the vehicle until the tire bottom is 0.3 m (0.98 ft) or more above the ground.
5. Shift the select lever to “D” range.
6. Check the waveform of primary speed sensor with engine idling running.
NOTE:
The waveform cycle changes as the speed changes.
Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Front Differential AssemblyADJUSTMENT1. Using the ST, screw-in the retainer until resistance is felt.NOTE:RH side should be screwed-in more than LH side.ST 18658AA020WRENCH COMPL RETAINER2. Remove the remaining liquid gasket from the mating surface c ...
Dtc u0122 lost communication with vehicle dynamics control module
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULEDetected when CAN data (vehicle speed signal) is not received from VDC.NOTE:Perform the diagnosis for LAN system. Basic Diagn ...
Inspection
GLASS/WINDOWS/MIRRORS > Power Window Control SwitchINSPECTION1. MAIN SWITCH• Driver’s seatCAUTION:Since the switch - power window main is controlled by CPU, do not check continuity for switch alone with the circuit tester. Performing continuity check with circuit tester can damage the ...