Subaru Crosstrek Service Manual: Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Pulley and Secondary Pulley
INSPECTION
• Check the surface of primary and secondary pulley cones for damage or wear.
• Check the primary and secondary pulley for damage.
• Check the bearing for seizure or wear.
• Apply CVTF to bearing and rotate the bearing to check for noise or dragging etc.
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Pulley and Secondary PulleyREMOVALNOTE:Always replace primary pulley and secondary pulley as an assembly because they are non-disassembled parts. ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Pulley and Secondary PulleyINSTALLATION1. Select shims for pulley alignment. Primary Pulley and Secondary Pulley > ADJUSTMENT">2. Ins ...
Other materials:
Bulkhead wiring harness (in compartment) Location
WIRING SYSTEM > Bulkhead Wiring Harness (In Compartment)LOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionB274B-4 Blower Resistor (manual A/C)B308BlackC-5 Front door cord RHB3110GrayC-1AB1Airbag wiring harnessB328B-2 Turn signal and hazard unitB4016BlackC-1 Data link connectorB412C-2 Po ...
Daylight saving time setting
1. Perform the preparation steps according
to "Preparation for date setting" 3-
56.
2. Operate the "
" or "
"
switch to
select the "Daylight Saving Time" item.
Then push the
button.
3. The current setting will be displayed.
Push the
button to enter the selection ...
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyREMOVAL1. Disconnect the ground cable from battery.2. Lift up the vehicle.3. Remove the rear exhaust pipe. Rear Exhaust Pipe > REMOVAL">4. Remove the propeller shaft. Propeller Shaft > REMOVAL"& ...
