CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft Assembly
INSPECTION
• Make sure that all component parts are free of scratches, holes and other faults.
• Check the tooth contact. Drive Pinion Shaft Assembly > ADJUSTMENT">
• Apply CVTF to bearing and rotate the bearing to check for noise or dragging etc.
• Check the starting torque of drive pinion shaft.
CAUTION:
Before measuring, apply differential gear oil to roller of bearing and rotate the bearing several times.
ST1 498937110 | HOLDER |
ST2 499787700 | WRENCH |
Starting torque:
5.1 — 17.1 N (0.5 — 1.7 kgf, 1.1 — 3.8 lbf)
Head restraint angle adjustment
The angle of the head restraint can be
adjusted in several steps. While maintaining
a suitable driving posture, adjust the
head restraint to a position where the back
of your head is as close to the head
restraint as possible.
To tilt:
Tilt the head restraint by hand to the
preferred p ...
Installation
CLUTCH SYSTEM > Operating CylinderINSTALLATION1. Install in the reverse order of removal.NOTE:• Before installing the operating cylinder, apply grease to the contact point of the release lever and operating cylinder.Grease:NICHIMOLY N-130 or equivalent• Be sure to install the clutch h ...
Removal
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and HoseREMOVAL1. NOZZLE - WINDSHIELD WASHER & HOSE1. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL">2. Remove the cowl panel - side and the cowl panel assembly. Cowl Panel > REMOVAL">CAUTION:Before ...