Subaru Crosstrek Service Manual: Inspection

Replace any faulty CVTF cooler hoses, CVTF cooler pipes and clamps found in the inspection below.

1. Check that there are no CVTF or engine coolant leaks from the connections.

2. Check the clamp for deformation.

3. Lightly bend the CVTF cooler hose and check for cracks in the surface or other damages.

4. Pinch the CVTF cooler hose with your fingers and check for poor elasticity. Also check for poor elasticity in the parts where the clamp was installed by pressing with your fingernail.

5. Check for peeling, cracks, and deformation at the tip of the hose.

6. Check the CVTF cooler (with warmer feature) for any damage.

Disassembly

Installation

Other materials:

Removal
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove the arm assembly - rear wiper.(1) Remove the cover - rear wiper arm.(2) Remove the nut, and remove the ...

Dtc p0458 evap system (cpc) purge control valve "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0458 EVAP SYSTEM (CPC) PURGE CONTROL VALVE "A" CIRCUIT LOWDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:Improper idlingCAUTION:After servicing ...

Dtc u0151 lost communication with restraints control module
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0151 LOST COMMUNICATION WITH RESTRAINTS CONTROL MODULEDetected when CAN data is not received from airbag CM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...