CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > General Description
INSPECTION
1. BATTERY
Check the battery. Battery > INSPECTION">
2. TRANSMISSION GROUND
Make sure that the ground terminal bolt is tightened securely.
Tightening torque:
14 N·m (1.4 kgf-m, 10.3 ft-lb)
3. OPERATION OF SHIFT SELECT LEVER
Make sure there is no noise, dragging or contact pattern in each select lever range.
WARNING:
Stop the engine while checking operation of the select lever.
Installation
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishINSTALLATIONCAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.Install each part in the reverse order of removal.Tightening torqueGarnish assembly - rear gate: 4.5 N·m (0.46 kgf-m, 3.3 f ...
Dtc c1521 motor relay
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1521 MOTOR RELAYDTC detecting condition:• Defective motor and motor relay• Defective harness connectorTrouble symptom:• ABS does not operate.• VDC does not operate.&b ...
Preparation
1. Turn off the ignition switch.
2. Close all doors (including rear gate).
3. Press and hold the " "
button on the
access key. All doors (including rear gate)
will then be locked.
4. Keep the " " button
pressed, and
press the rear lock button within 5
seconds after step ...