Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > AT OIL TEMP Warning Light Display

INSPECTION

DIAGNOSIS:

CAN communication is lost with the combination meter.

Combination meter malfunction

TCM is in special control mode.

AT learning is not finished.

TROUBLE SYMPTOM:

When the ignition switch is turned to ON, the AT OIL TEMP light does not illuminate.

AT OIL TEMP light remains lit after engine start.

STEPCHECKYESNO

1.CHECK DTC.

Read the DTC relating the TCM using the Subaru Select Monitor.

Is DTC U0155 or U0423 displayed?

Perform the self-diagnosis of combination meter.

AT OIL TEMP Warning Light Display > INSPECTION">Go to Step 2.

2.CHECK DTC.

Read the DTC relating the TCM using the Subaru Select Monitor.

Are DTCs other than U0155 and U0423 displayed?

Perform the diagnosis according to DTC.

AT OIL TEMP Warning Light Display > INSPECTION">Go to Step 3.

3.CHECK COMBINATION METER.

Read DTC of combination meter.

Is DTC displayed?

Perform the diagnosis according to DTC.

AT OIL TEMP Warning Light Display > INSPECTION">Go to Step 4.

4.CHECK AT OIL TEMP LIGHT.

Turn the ignition switch to ON.

Does AT OIL TEMP light illuminate and then go off in 2 seconds?

AT OIL TEMP Warning Light Display > INSPECTION">Go to Step 5.

Perform the self-diagnosis of combination meter. Combination Meter System > OPERATION">

5.CHECK AT OIL TEMP LIGHT.

Start the engine.

Does the AT OIL TEMP light go off?

Current condition is normal. Go back to Basic Diagnostic Procedure. Basic Diagnostic Procedure">

AT OIL TEMP Warning Light Display > INSPECTION">Go to Step 6.

6.CHECK DTC.

Read the DTC relating the TCM using the Subaru Select Monitor.

Is DTC displayed?

Perform the diagnosis according to DTC.

AT OIL TEMP Warning Light Display > INSPECTION">Go to Step 7.

7.CHECK TCM.

Read the data of «ATF Temperature Lamp» using the Subaru Select Monitor.

Is “ON” displayed?

AT OIL TEMP Warning Light Display > INSPECTION">Go to Step 8.

Perform the self-diagnosis of combination meter. Combination Meter System > OPERATION">

8.CHECK TCM.

Read the data of «ATF Temp.» using the Subaru Select Monitor.

Is the display 125°C or more?

AT OIL TEMP Warning Light Display > INSPECTION">Go to Step 9.

Replace the TCM. Transmission Control Module (TCM)">

9.CHECK ATF TEMPERATURE.

Check the real fluid temperature from the transmission case surface temperature.

Does it clearly differ from the «ATF Temp.» displayed on Subaru Select Monitor?

Perform the diagnosis according to DTC P0712. If there is no problem, perform the diagnosis according to DTC P0713.

When ATF temperature can be judged as actually high, perform the diagnosis again after the ATF temperature lowers.

At oil temp warning light display
...

Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > AT OIL TEMP Warning Light DisplayOPERATIONThe AT OIL TEMP light illuminates or blinks, when the ATF temperature is high and malfunction occurs in ...

Other materials:

65
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code65Cruise control command switch malfunction is detected.While the command switch is pressed ON for a long time (approximately two minutes), stuck ON condition is detected.TROUBLE SYMPTOM:• Cruise control cannot be se ...

Inspection
ENTERTAINMENT > Rearview Camera SystemINSPECTION1. Park the vehicle at the level place where there are enough area at the rear of the vehicle.2. Attach the tape as the target point for standard at the floor rearward of the vehicle as shown in the figure below.NOTE:Standard tape width is about 30 ...

Batch save of event record data Operation
AIRBAG SYSTEM (DIAGNOSTICS) > Batch save of Event record dataOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» displa ...

© 2016-2022 Copyright www.sucross.com