COMMUNICATION SYSTEM > Relay and Fuse
INSPECTION
1. CHECK FUSE
1. Remove the fuse and check visually.
2. If the fuse is blown out, replace the fuse.
2. CHECK RELAY
1. Check the resistance between relay terminals.
Terminal No. | Inspection conditions | Specification | Circuit |
1 — 2 | Always | 1 M? or more |

1 — 2
Apply battery voltage between 4 — 3 terminals.
Less than 1 ?
2. Replace the relay if the inspection result is not within the standard value.
Relay and fuse
LocationInspection
POWER ASSISTED SYSTEM (POWER STEERING) > Steering WheelINSPECTION1. PADDLE SHIFT SWITCHCheck the resistance of paddle switch.STEPCHECKYESNO1.SHIFT-UP SWITCH CONTINUITY CHECK.1) Operate the + side of paddle shift assembly and hold it.2) Measure the resistance between terminals of the paddle shift ...
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">3 ...
Inspection
LIGHTING SYSTEM > Ignition Switch IlluminationINSPECTIONSTEPCHECKYESNO1.CHECK THE IGNITION SWITCH ILLUMINATION.Make sure the ignition switch illumination illuminates when driver’s side door is open.Does the ignition switch illumination illuminate?Ignition switch illumination is normal. Igni ...