Subaru Crosstrek Service Manual: Inspection

Subaru Crosstrek Service Manual / Communication system / Horn switch / Inspection

COMMUNICATION SYSTEM > Horn Switch

INSPECTION

1. CHECK HORN SWITCH

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Turn the ignition switch to OFF.

2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

3. Remove the driver’s airbag module. Driver’s Airbag Module > REMOVAL">

4. Check that the connection of the horn switch harness connector is correct.

5. Disconnect the horn switch harness connector and check the resistance between the harness connectors.

Preparation tool:

Circuit tester

(a)

Ground terminal

(b)

Horn switch terminal

Terminal No.	Inspection conditions	Standard
Horn switch terminal — ground terminal	Always	Less than 1 ?

6. Replace the driver’s airbag module if the inspection result is not within the standard value.

2. CHECK ROLL CONNECTOR

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• If the steering wheel and steering angle sensor (steering roll connector) are removed, be sure to perform the following operations.

– Align the center position of the steering roll connector.

– Perform the neutral position setting of the steering angle sensor.

1. Turn the ignition switch to OFF.

2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

3. Remove the roll connector. Roll Connector > REMOVAL">

4. Check the resistance between roll connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
A1 — C9	Always	Less than 1 ?

5. Replace the roll connector if the inspection result is not within the standard value.

Note

COMMUNICATION SYSTEM > Horn SwitchNOTEHorn switch is a unit with the driver’s airbag module. For operation procedures, refer to “Driver’s Airbag Module” in “AIRBAG SYS ...

Other materials:

Washing
CAUTION When washing the vehicle, the brakes may get wet. As a result, the brake stopping distance will be longer. To dry the brakes, drive the vehicle at a safe speed while lightly depressing the brake pedal to heat up the brakes. Do not wash the engine compartment and area ad ...

Replacement
SECURITY AND LOCKS > Access KeyREPLACEMENT1. ACCESS KEY REGISTRATIONNOTE:• A maximum of seven access keys can be registered for each individual vehicle.• When replacing or adding an access key, new registration of the access key is necessary.• When the access key has been newly ...

Manual transmission
The manual transmission is a fully synchromeshed, 5-forward-speed and 1-reverse- speed transmission. The shift pattern is shown on the shift lever knob. When shifting from 5th gear to reverse gear, first return the shift lever to the neutral position then shift into reverse gear. To ...