Subaru Crosstrek Service Manual: Inspection
CLUTCH SYSTEM > Flywheel
INSPECTION
CAUTION:
Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.
1. If there is damage or defectiveness in the facing sliding surface or ring gear, replace the flywheel.
(A) | Flywheel |
(B) | Ring gear |
2. Smoothness of rotation
Rotate the ball bearing while applying pressure in the thrust direction.
3. If noise or excessive play is noted, replace the pilot bearing.
Flywheel
...
Removal
CLUTCH SYSTEM > FlywheelREMOVAL1. Remove the transmission assembly. Manual Transmission Assembly > REMOVAL">2. Remove the clutch cover and clutch disc. Clutch Disc and Cover > REMOV ...
Other materials:
Rear window wiper blade assembly
1. Raise the wiper arm off the rear
window.
2. Turn the wiper blade assembly counterclockwise.
3. Pull the wiper blade assembly toward
you to remove it from the wiper arm.
4. Install the wiper blade assembly to the
wiper arm. Make sure that it locks in place.
5. Hold the wiper arm ...
Certification for immobilizer system
For models with "keyless access
with push-button start system":
Refer to "Certification for keyless access
with push-button start system" 2-19.
For models without "keyless access
with push-button start system":
U.S.-spec. models
FCC ID: MOZRI-38BFH
CAUTION
FCC WARNING
Chang ...
Removal
COMMUNICATION SYSTEM > HornREMOVALCAUTION:Do not remove the bumper face - front when removing the horn, in order to prevent damaging the claws of the bracket - front bumper corner and the bracket - front bumper side.1. Disconnect the ground cable from battery. NOTE">2. Remove the clip, a ...
