Subaru Crosstrek Service Manual: Inspection
CLUTCH SYSTEM > Clutch Pedal
INSPECTION
Move the clutch pedal pads in the lateral direction with a force of approximately 10 N (1 kgf, 2 lbf) to check that the clutch pedal deflection is within the service limit. If it exceeds the service limit, replace with new bushings.
Deflection of the clutch pedal:
Service limit
4.0 mm (0.157 in) or less
(A) | Clutch pedal |
(B) | Brake pedal |
Disassembly
CLUTCH SYSTEM > Clutch PedalDISASSEMBLY1. Remove the clutch switches.2. Remove the clip, assist spring, rod and bushing.(A)Clip(B)Assist spring(C)Assist rod(D)Bushing(E)Clevis pin3. Remove the spri ...
Installation
CLUTCH SYSTEM > Clutch PedalINSTALLATION1. Install in the reverse order of removal.CAUTION:Always use a new clevis pin.Tightening torque:Clutch pedal18 N·m (1.8 kgf-m, 13.3 ft-lb)Knee airbag ...
Other materials:
Dtc c1721 yaw rate sensor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1721 YAW RATE SENSORDTC DETECTING CONDITION:Defective yaw rate & G sensorTROUBLE SYMPTOM:• ABS does not operate.• VDC does not operate.• Hill start assist does not oper ...
Removal
DIFFERENTIALS > Rear Differential (T-type)REMOVAL1. Shift the select lever or gear shift lever to neutral.2. Release the parking brake.3. Disconnect the ground cable from battery.4. Lift up the vehicle.5. Remove the rear wheels.6. Drain differential gear oil. Differential Gear Oil > REPLACEME ...
Dtc b1822 short in side airbag rh (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1822 SHORT IN SIDE AIRBAG RH (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Side airbag harness (RH) circuit is shorted to ground.• Side airbag module (RH) is faulty.& ...
