BRAKE > Rear Disc Rotor
INSPECTION
1. DISC ROTOR RUNOUT CHECK
1. Check the hub unit COMPL - rear axle for free play and runout before the inspection of disc rotor runout limit. Rear Hub Unit Bearing > INSPECTION">
2. Check the disc rotor runout.
(1) Remove the caliper body assembly. Rear Disc Brake Assembly > REMOVAL">
(2) Secure the disc rotor by tightening the five wheel nuts.
(3) Set a dial gauge 10 mm (0.39 in) inward from the disc rotor outer circumference, and check the outer disc rotor runout while rotating the disc rotor.
Disc rotor runout limit:
0.05 mm (0.0020 in)
(4) Set a dial gauge 10 mm (0.39 in) inward from the disc rotor outer circumference, and check the inner disc rotor runout while rotating the disc rotor.
Disc rotor runout limit:
0.05 mm (0.0020 in)
3. If the disc rotor runout exceeds service limit, resurface the disc rotor.
4. Check the disc rotor thickness after resurfacing. Rear Disc Rotor > INSPECTION">
2. DISC ROTOR THICKNESS CHECK
1. Set a micrometer 10 mm (0.39 in) inward from the disc rotor outer perimeter, and then measure the disc rotor thickness (A).
Type of disc rotor | Standard | Wear limit | Disc rotor outer diameter | |
Disc rotor thickness (A) | Solid disc | 10 mm (0.39 in) | 8.5 mm (0.33 in) | 274 mm (10.79 in) |
2. If the wear limit is exceeded in the inspection, replace the disc rotor.
Dtc b2271 ign relay control circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2271 IGN RELAY CONTROL CIRCUITDTC detecting condition:• When malfunction is detected in IG1 and IG2 drive circuits in the keyless access CM.• When malfunction is de ...
Specification
LIGHTING SYSTEM > General DescriptionSPECIFICATIONNo.DescriptionCapacity and wattageType(1)HeadlightLow beam (halogen type)12 V — 55 WH11Low beam (HID type)12 V — 35 WD2RHigh beam12 V — 60 WHB3Front turn signal light12 V — 21 WWY21WParking light12 V — 5 WW5WSide marker light12 V — 5 W ...
Windshield wiper blade assembly
1. Raise the wiper arm off the windshield.
1) Stopper
2. Remove the wiper blade assembly by
holding its pivot area and pushing it in the
direction shown by the arrow while depressing
the wiper blade stopper.
3. Install the wiper blade assembly to the
wiper arm. Make sure that it locks i ...