BRAKE > Front Disc Rotor
INSPECTION
1. DISC ROTOR RUNOUT CHECK
1. Check the hub unit COMPL - front axle for free play and runout before the inspection of disc rotor runout limit. Front Hub Unit Bearing > INSPECTION">
2. Tighten the wheel nuts to secure disc rotor.
3. Set a dial gauge 10 mm (0.39 in) inward from the disc rotor outer circumference, and check the disc rotor runout while rotating the disc rotor.
Disc rotor runout limit: 0.05 mm (0.0020 in)
4. If the disc rotor runout exceeds service limit, resurface the disc rotor.
5. Check the disc rotor thickness after resurfacing. Front Disc Rotor > INSPECTION">
2. DISC ROTOR THICKNESS CHECK
1. Set a micrometer 10 mm (0.39 in) inward from the disc rotor outer perimeter, and then measure the disc rotor thickness (A).
Size | Standard | Wear limit | Disc rotor outer diameter | |
Disc rotor thickness (A) | 15-inch | 24 mm (0.94 in) | 22 mm (0.87 in) | 277 mm (10.91 in) |
16-inch | 294 mm (11.57 in) |
2. If the wear limit is exceeded in the inspection, replace the disc rotor.
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Heater Vent DuctINSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">Install each part in the reve ...
Odometer
Type A
Trip knob
Type B
Trip knob (U.S.-spec. models)
Trip knob (except U.S.-spec. models)
This meter displays the odometer when
the ignition switch is in the "ON" position.
The odometer shows the total distance
that the vehicle has been driven.
If you press the trip knob ...
Removal
EXTERIOR/INTERIOR TRIM > Rear Gate TrimREMOVAL1. Remove the trim panel - rear gate UPR.(1) Remove the claws on the trim edge.(2) Release the claws in the center of trim, and remove the trim panel - rear gate UPR.2. Remove the trim panel - rear gate pillar side.(1) Release the claws.(2) Remove the ...