Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

BRAKE > Brake Pedal

INSPECTION

1. Move the pad - brake pedal in a horizontal direction with a force of approx. 10 N (1 kgf, 2 lbf), and check that the pedal deflection is in the range of specifications.

CAUTION:

If excessive deflection is noted, replace with a new bushing.

Deflection of brake pedal:

Wear limit: 5.0 mm (0.197 in) or less

(a)

Brake pedal (except for MT model)

(b)

Brake pedal (MT model)

2. Check the position of the pedal pad.

Pedal height L:

140 — 150 mm (5.51 — 5.91 in)

Brake pedal free play A:

0.5 — 2.7 mm (0.02 — 0.11 in) [When pulling the brake pedal upward with a force of less than 10 N (1 kgf, 2 lbf).]

(a)

Stop light switch

(c)

Toe board

(d)

Brake booster operating rod

(b)

Mat

3. If it is not within the specification, loosen the lock nuts of vacuum booster operating rod, and rotate the rod to adjust the pedal height L within the specification.

4. Tighten the lock nut.

Tightening torque:

Operating lock nut: 22 N·m (2.24 kgf-m, 16.2 ft-lb)

NOTE:

Check the brake pedal height. When adjusting, also adjust the stop light switch.

Brake pedal
...

Removal
BRAKE > Brake PedalREMOVAL1. CVT MODELCAUTION:Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM” ...

Other materials:

Inspection
CLUTCH SYSTEM > FlywheelINSPECTIONCAUTION:Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.1. If there is damage or defectiveness in the facing sliding surface or ring gear, replace the flywheel.(A)Flywheel(B)Ring gear2. Smooth ...

Removal
EXTERIOR/INTERIOR TRIM > Rear Quarter TrimREMOVAL1. CROSSTREK MODELCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system sat ...

Inspection
GLASS/WINDOWS/MIRRORS > Remote Control Mirror SwitchINSPECTION1. Disconnect the connector of the switch - door mirror.2. Check the resistance between switch - door mirror terminals.Preparation tool:Circuit tester• Changeover switch RHTerminal No.Inspection conditionsStandard — OFF1 M? or ...

© 2016-2022 Copyright www.sucross.com