Subaru Crosstrek Owners Manual: Initial screen
When the ignition switch is in the "ACC" or "ON" position, the initial screen will be displayed and the system will begin operating.
- When using the SUBARU STARLINK function (if equipped), the display screen may be different from the screen above.
- After a few seconds, the caution screen will be displayed.
- After about 5 seconds, the caution screen automatically switches to the next screen.
Entering letters and numbers/list screen operation
Entering letters and numbers
When entering the Bluetooth device name
or PIN-code, or the phone number, letters
and numbers can be entered via the
screen.
Enter letters (example: In-Car-Device ...
Connecting and disconnecting a USB memory/portable device
The USB port and the AUX jack are
located as shown in the following illustration.
NOTE
This unit does not support commercially
available USB hubs.
Turn on the power of the device
when ...
Other materials:
Caution
AIRBAG SYSTEM > General DescriptionCAUTION1. BEFORE STARTING ALL WORKS• Before performing vehicle maintenance, turn the ignition switch to OFF and disconnect the negative terminal from battery. NOTE">• The airbag system (including pretensioner) is fitted with a backup power s ...
Dtc p0752 shift solenoid "a" stuck on
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0752 SHIFT SOLENOID "A" STUCK ONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Acceleration is poor during standi ...
Dtc u0401 invalid data received from ecm/pcm a
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0401 INVALID DATA RECEIVED FROM ECM/PCM “A”Detected when there is malfunction in CAN data from the engine control module (ECM).NOTE:Perform the diagnosis for LAN sy ...
