Subaru Crosstrek Owners Manual: Initial illumination for system check
Several of the warning and indicator lights illuminate when the ignition switch is initially turned to the "ON" position. This permits checking the operation of the bulbs.
Apply the parking brake and turn the ignition switch to the "ON" position. For the system check, the following lights illuminate and then turn off after several seconds or after the engine has started.
Seatbelt
warning light
(The seatbelt warning light turns off
only when the driver fastens the
seatbelt.)
:
Front passenger's seatbelt warning
light
(The seatbelt warning light turns off
only when the front seat passenger
fastens the seatbelt.)
SRS
airbag system warning light
Front
passenger's frontal airbag
ON indicator light
Front
passenger's frontal airbag
OFF indicator light
CHECK
ENGINE warning light/Malfunction
indicator light
Coolant
temperature low indicator
light/Coolant temperature high warning
light
Charge
warning light
Oil
pressure warning light
Engine
low oil level warning light
(models with type A combination
meter)
Windshield
washer fluid warning light
(models with type A combination
meter)
AT
OIL TEMP warning light
(CVT models)
Low
tire pressure warning light
(U.S.- spec. models)
ABS
warning light
Brake
system warning light
Low
fuel warning light
Hill
start assist warning light/Hill start
assist OFF indicator light
Door
open warning light
AWD
warning light (CVT models)
Power
steering warning light
Vehicle
Dynamics Control warning
light/Vehicle Dynamics Control operation
indicator light
Vehicle
Dynamics Control OFF indicator
light
Automatic
headlight beam leveler
warning light (models with HID headlights)
If any lights fail to illuminate, it indicates a burned-out bulb or a malfunction of the corresponding system.
Consult your authorized SUBARU dealer for repair.
Seatbelt warning light and chime
Your
vehicle is equipped with a seatbelt
warning device at the driver's and front
passenger's seat, as required by current
safety standards.
With the ignition switch turned to the "ON"
posi ...
Other materials:
Activating and deactivating the alarm system
To change the setting of your vehicle's
alarm system for activation or deactivation,
do the following.
1. Disarm the alarm system. Refer to
"Disarming the system" 2-30.
2. Sit in the driver's seat and shut all
doors and the rear gate.
3. Turn the ignition switch to the "ON"
position.
...
Removal
LIGHTING SYSTEM > Spot Map LightREMOVAL1. MODELS WITHOUT EyeSight1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - map.CAUTION:When using a flat tip screwdriver, use an appropriate sized tool for the insertion opening, apply protective tape or cloth around ...
Dtc b16f4 side airbag sensor rh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F4 SIDE AIRBAG SENSOR RH RECOGNITION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Side airbag sensor RH is misinstalled.• Airbag CM is faulty.CAUTION:Before performing d ...
