Subaru Crosstrek Service Manual: Inhibitor switch Note
CRUISE CONTROL SYSTEM > Inhibitor Switch
NOTE
For the operation procedures for inhibitor switch, refer to “CONTINUOUSLY VARIABLE TRANSMISSION” section. Inhibitor Switch">
Diagnostics with phenomenon Inspection
CRUISE CONTROL SYSTEM > Diagnostics with PhenomenonINSPECTIONRefer to “Diagnostics with Phenomenon” of “CRUISE CONTROL SYSTEM (DIAGNOSTICS)” section. Diagnostics with Pheno ...
Neutral position switch Note
CRUISE CONTROL SYSTEM > Neutral Position SwitchNOTEFor the operation procedures for neutral position switch, refer to “MANUAL TRANSMISSION AND DIFFERENTIAL” section. Switches and Harne ...
Other materials:
Bulkhead wiring harness (in engine compartment) Location
WIRING SYSTEM > Bulkhead Wiring Harness (In Engine Compartment)LOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionB35BlackB-2 Mass air flow and intake air temperature sensorB62Light grayC-3 Front ABS wheel speed sensor RHB85Light grayB-5 Front wiper motorB104Light grayC-4 Pressure switch ...
Dtc p0458 evap system (cpc) purge control valve "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0458 EVAP SYSTEM (CPC) PURGE CONTROL VALVE "A" CIRCUIT LOWDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:Improper idlingCAUTION:After servicing ...
Removal
LIGHTING SYSTEM > Door SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the switch assembly - door.(1) Remove the screws, and pull out the switch assembly - door toward you.(2) Disconnect the connector and remove the switch assembly - door. ...
