Subaru Crosstrek Service Manual: Immobilizer (diagnostics)
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc b1401 meter collation
- Dtc b1571 reference code incompatibility (immobilizer cm to ecm)
- Dtc b1402 immobilizer key collation
- Dtc b1405 scu collation
- Dtc b1406 scu_eeprom
- Dtc b1407 met communication
- Dtc b1408 meter non-volatile memory
- Dtc b1409 scu communication
- Dtc b1410 transponder communication
- Dtc b1411 immobilizer antenna
- Dtc b1570 antenna
- Dtc b1572 imm circuit except antenna circuit
- Dtc b1574 key communication
- Dtc b1575 incorrect immobilizer key
- Dtc b1576 egi control module eeprom
- Dtc b1577 imm control module eeprom
- Dtc b1578 meter
- General description
- Basic diagnostic procedure Procedure
- Clear memory mode Operation
- Diagnostics chart for security indicator light Inspection
- Electrical component location Location
- Immobilizer control module i/o signal Wiring diagram
- List of diagnostic trouble code (dtc) List
- Read diagnostic trouble code (dtc) Operation
- Subaru select monitor Operation
Installation
IGNITION(H4DO) > Spark PlugINSTALLATION1. RH SIDEInstall in the reverse order of removal.CAUTION:Degrease the ignition coil installation portion and the mounting bolts.Tightening torque:Spark plug1 ...
Other materials:
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Heater CoreREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Using the refrigerant recovery syste ...
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveASSEMBLY1. Install the return spring (1st-2nd), return spring cap, reverse accent shaft, reverse check cam, return spring (5th-Reverse) and reverse check spring.NOTE:Be sure to insert the curved part of reverse check spring into the ...
Adjustment
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Compressor OilADJUSTMENT• If a component has been replaced, add an appropriate amount of compressor oil (same as the amount of remaining oil in removed component).• When replacing the compressor assembly, the new compressor assembly will alre ...
