The immobilizer system is designed to prevent an unauthorized person from starting the engine. Only keys registered with your vehicle's immobilizer system can be used to operate your vehicle. This system, however, is not a 100% anti-theft guarantee.
For models with "keyless access with push-button start system": If you press the push-button ignition switch when carrying an unregistered access key, the switch will not turn to the "ON" position and the engine will not start.
If the engine does not start, perform the procedure described in "Starting engine" 9-18.
For models without "keyless access with push-button start system": Even if an unregistered key fits into the ignition switch and can be turned to the "START" position, the engine will automatically stop after several seconds.
If the engine does not start, pull out the key once before trying again. Refer to "Ignition switch (models without "keyless access with push-button start system")" 3-4.
CAUTION
NOTE
To protect your vehicle from theft, please pay close attention to the following security precautions:
The vehicle has a maintenance-free type immobilizer system.
Security indicator light
Refer to "Security indicator light" 3-30.
Keys
Key replacementDisassembly
EXHAUST(H4DO) > Front Exhaust PipeDISASSEMBLY1. Remove the front oxygen (A/F) sensor and rear oxygen sensor from front exhaust pipe. Front Oxygen (A/F) Sensor > REMOVAL"> Rear Oxygen Sensor > REMOVAL">2. Remove the center exhaust pipe from the front exhaust pipe.3. Remove ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Case and Extension Case AssemblyINSTALLATION1. Clean the mating surfaces of the transmission case, transfer case and extension case.2. Apply a coat of grease to the taper roller bearing (transfer case side) of transfer driven gear and the rolle ...
Hill start assist system
WARNING
The Hill start assist system in the Subaru Ascent is intended only to
assist when starting on an incline.
It is not a substitute for proper parking procedures. Always engage the
parking brake and confirm the vehicle remains stationary before releasing the
brake pedal.
...