Subaru Crosstrek Owners Manual: If your vehicle is involved in an accident
CAUTION
If your vehicle is involved in an accident, be sure to inspect the ground under the vehicle before restarting the engine. If you find that fuel has leaked on the ground, do not try to restart the engine. The fuel system has been damaged and is in need of repair. Immediately contact the nearest automotive service facility.
We recommend that you consult your SUBARU dealer.
Your vehicle has a fuel pump shut off system. To minimize the risk of fire due to fuel leakage when your vehicle is subject to impact from an accident or another factor, the system stops supplying fuel.
However, depending on the impact conditions at the time of collision, the fuel pump shut-off system may not operate.
Perform the following procedures to restart the engine after the system is activated.
Models without "keyless access with push-button start system":
1. Turn the ignition switch to the "LOCK" or "ACC" position.
2. Restart the engine.
1. Turn the ignition switch to the "LOCK" or "ACC" position.
2. Restart the engine.
1. Turn the push-button ignition switch to the "ACC" or "OFF" position.
2. Restart the engine.
Rear gate - if the rear gate cannot be opened
In the event that you cannot open the rear
gate by operating the rear gate opener
button, you can open it from inside the
cargo area.
1. Remove the access cover at the
bottom-center of the re ...
Appearance care
...
Other materials:
Specification
STARTING/CHARGING SYSTEMS(H4DO) > General DescriptionSPECIFICATIONItemSpecificationsVehicle modelCVTMTStarterTypeReduction typeModelM000T38571M000T33176ManufacturerMitsubishi ElectricVoltage and output12 V — 1.2 kW12 V — 1.0 kWDirection of rotationCounterclockwise (when observed from pinion)N ...
Removal
SECURITY AND LOCKS > Rear Gate Latch and Actuator AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove the latch and actuator - rear gate.(1) Disconnect the connector.(2) Remove the bolts, ...
Shift lock function
The shift lock function helps prevent the
improper operation of the select lever.
The select lever cannot be operated
unless the ignition switch is turned to the
"ON" position and the brake pedal is
depressed.
The select lever cannot be moved from
the "P" position to any other positio ...
