The hazard warning flasher should be used in day or night to warn other drivers when you have to park your vehicle under emergency conditions.
Avoid stopping on the road. It is best to safely pull off the road if a problem occurs.
The hazard warning flasher can be activated regardless of the ignition switch position.
Turn on the hazard warning by pushing the hazard warning flasher switch. Turn it off by pushing the switch again.
NOTE
When the hazard warning flasher is on, the turn signals do not work.
Roof antenna (for Rod type)
CAUTION
Be sure to remove the antenna
rod before entering garages,
parking towers and other locations
with low ceilings.
Remove the antenna rod before
washing your car at a car wash. If
the antenna rod is left attached, it
may scratch the roof.
When reinstalling the removed
ant ...
Basic diagnostic procedure Procedure
LAN SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Subaru Select Monitor is required for reading DTC, performing diagnosis, reading current data, customizing and active test (compulsory drive).• Remove foreign matter (dust, water, oil, etc.) from each control modu ...
Installation
FRONT SUSPENSION > Front Ball JointINSTALLATION1. Install the ball joint assembly to the housing assembly - front axle.CAUTION:• Do not apply grease to the tapered portion of ball stud.• Before tightening, make sure the bottom surface of the housing assembly - front axle and the stepp ...