Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Idle speed Inspection

MECHANICAL(H4DO) > Idle Speed

INSPECTION

1. Before checking the idle speed, check the following item:

(1) Check the air cleaner element is free from clogging, ignition timing is correct, spark plugs are in good condition, and hoses are connected properly.

(2) Check the malfunction indicator light does not illuminate.

2. Warm up the engine.

3. Read the engine idle speed using Subaru Select Monitor. Subaru Select Monitor > OPERATION">

NOTE:

Idle speed cannot be adjusted manually, because the idle speed is automatically adjusted.

If idle speed is out of standard, refer to the General Diagnosis Table under “Engine Control System”. Basic Diagnostic Procedure">

(1) Check the idle speed when no-loaded. (Headlight, blower fan, rear defroster, radiator fan, A/C and etc. are OFF)

Idle speed (No load, and for CVT model, select lever in “P” or “N” range, for MT model, gear shift lever in neutral position.):

Standard

650±100 r/min

(2) Check the idle speed when loaded. (Turn the A/C switch to ON and operate the compressor for at least one minute before measurement.)

Idle speed (A/C on, and for CVT model, select lever in “P” or “N” range, for MT model, gear shift lever in neutral position.):

Standard

800 — 900±50 r/min

Fuel pressure Inspection
MECHANICAL(H4DO) > Fuel PressureINSPECTION1. Release the fuel pressure. Fuel > PROCEDURE">2. Open the fuel filler lid and remove the fuel filler cap.NOTE:This operation is required to r ...

Ignition timing Inspection
MECHANICAL(H4DO) > Ignition TimingINSPECTIONCAUTION:After warming-up, engine becomes very hot. Be careful not to burn yourself at measurement.1. Before checking the ignition timing, check the follo ...

Other materials:

Replacement
DIFFERENTIALS > Rear Differential Mount BushingREPLACEMENTCAUTION:• If there was so much rust in the rear differential mount bushing, remove the rust before starting work.• Apply the molybdenum grease on the square thread of the ST (shaft and nut) before use.1. Remove the rear differe ...

Removal
LIGHTING SYSTEM > Combination Switch (Light)REMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Set the tire to the straight-ahead position.2. ...

Dtc b2350 rear radar communication error between master and slave
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2350 REAR RADAR COMMUNICATION ERROR BETWEEN MASTER AND SLAVEDTC DETECTING CONDITION:• Defective harness for CAN communication between radar sensor LH and radar sensor RH ...

© 2016-2024 Copyright www.sucross.com