Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: How to use the rear view camera

When the shift lever/select lever is set to "R", the rear view camera automatically displays the rear view image from the vehicle. When the lever is set to other positions, the image before setting to "R" is displayed.

1. Set the ignition switch to "ON".

2. Set the shift lever/select lever to "R".

NOTE

For models with the genuine SUBARU navigation system or audio system, while the navigation system is activated, the image of the rear view camera will not be displayed. However, the image of the rear view camera has priority over other screen displays.

The image of the rear view camera is horizontally reversed as is the case with the vehicle rearview mirror or the side view mirror.

It may be difficult to see the rear view camera image in the following cases. This is not a malfunction of the camera.

Rear view camera
A rear view camera is attached to the rear gate. When the ignition switch is "ON" and the shift lever (MT models) or select lever (CVT models) is set to "R", the rear view camera automatically ...

Viewing range on the screen
CAUTION The range that can be viewed with the rear view camera is limited. Always be sure to check with your eyes when moving backward and proceed slowly. Range of view Range of view ...

Other materials:

Dtc b1807 short in passenger s airbag (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1807 SHORT IN PASSENGER’S AIRBAG (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted to ground.• Airbag module harness (passeng ...

Installation
COOLING(H4DO) > ThermostatINSTALLATION1. ENGINE SIDE1. Install a gasket to thermostat.NOTE:Use a new gasket.2. Install the thermostat and thermostat cover.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)(A)Thermostat cover(B)Gasket(C)Thermostat3. Connect the radiator outlet hose to thermos ...

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyINSTALLATION1. Attach the needle bearing and oil seal to the front of the main shaft assembly.NOTE:• Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.• Apply NICHIMOLY N-130 or the equivale ...

© 2016-2022 Copyright www.sucross.com