Subaru Crosstrek Owners Manual: How to change the source
The USB Audio playback screen can be reached by the following methods:
- Connect a USB memory. Refer to "Connecting and disconnecting a USB memory/portable device"
- Select the "USB/iPod" key on the source select screen. Refer to "Selecting an audio source"
Select play mode
The play mode settings display will appear when play mode key is touched. Select the preferred play mode from the following items.
| Icon | Function |
 |
Touch to start 1 track repeat. |
 |
Touch to start repeat all. |
 |
Touch to start folder repeat. |
 |
Touch to start shuffle all. |
 |
Touch to start shuffle folder. |
 |
Return to the control screen. |
Control screen and audio panel
Select to display the audio source
selection screen.
Select to display the play mode
currently selected. Refer to "Select
play mode"
Select to display folder list.
Shows progress.
...
iPod
Audio files on the iPod can be played.
WARNING
Do not operate the player's controls
or connect the iPod while driving.
Doing so may result in loss of
control of your vehicle and cause
an accid ...
Other materials:
Ignition timing Inspection
MECHANICAL(H4DO) > Ignition TimingINSPECTIONCAUTION:After warming-up, engine becomes very hot. Be careful not to burn yourself at measurement.1. Before checking the ignition timing, check the following item:(1) Check the air cleaner element is free from clogging, spark plugs are in good condition ...
Diagnostic procedure with cancel code Dtc b2328 rear radar internal failure (radar misalignment)
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Cancel CodeDTC B2328 REAR RADAR INTERNAL FAILURE (RADAR MISALIGNMENT)DETECTING CONDITION:• Excessive impact was given to the installation area of the radar sensor, which resulted in deviation of the rada ...
How to use the rear view camera
When the shift lever/select lever is set to
"R", the rear view camera automatically
displays the rear view image from the
vehicle. When the lever is set to other
positions, the image before setting to "R"
is displayed.
1. Set the ignition switch to "ON".
2. Set the shift lever/select leve ...
