Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Hill start assist warning light does not go off

VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination Pattern

HILL START ASSIST WARNING LIGHT DOES NOT GO OFF

Detecting condition:

Defective combination meter

Defective CAN communication

Trouble symptom:

Hill start assist warning light does not go off when starting the engine.

STEPCHECKYESNO

1.READ DTC.

Read the DTC. Read Diagnostic Trouble Code (DTC)">

Is DTC displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Warning Light Illumination Pattern > HILL START ASSIST WARNING LIGHT DOES NOT GO OFF">Go to Step 2.

2.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system. Basic Diagnostic Procedure">

Is there any fault in LAN system?

Perform the diagnosis according to DTC for LAN system. List of Diagnostic Trouble Code (DTC)">

Warning Light Illumination Pattern > HILL START ASSIST WARNING LIGHT DOES NOT GO OFF">Go to Step 3.

3.CHECK COMBINATION METER.

Check the combination meter. Combination Meter System > OPERATION">

Is the check result OK?

• Models without EyeSight
Replace the VDCCM only. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > REPLACEMENT">
• Models with EyeSight
Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

Replace the combination meter. Combination Meter">

Inspection
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternINSPECTION(1)Ignition switch(6)Light OFF(11)2 seconds or more(2)OFF(7)Light ON(12)Brake warning light (EBD warning l ...

Ebd warning light, abs warning, vdc off indicator light, vdc warning light and vdc indicator light do not come on
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternEBD WARNING LIGHT, ABS WARNING, VDC OFF INDICATOR LIGHT, VDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT COME ONDet ...

Other materials:

Interior light off delay timer setting
1. Perform the preparation steps according to "Preparation for car settings" 2. Operate the " " or " " switch to select the "Interior Light" item. Then push the  button. 3. The current setting will be displayed. Push the button to enter the selection mode. 4. Select ...

Steering angle sensor Replacement
VEHICLE DYNAMICS CONTROL (VDC) > Steering Angle SensorREPLACEMENTCAUTION:• If the steering wheel and steering angle sensor are removed, perform the following VDC setting mode.– Model without EyeSight: VDC sensor midpoint setting mode VDC Control Module and Hydraulic Control Unit (VDCCM& ...

Replacement
SECURITY AND LOCKS > Keyless TransmitterREPLACEMENT1. REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITORNOTE:• A maximum of four keyless transmitters can be registered for each individual vehicle.• When replacing or adding the keyless transmitter, new registration of trans ...

© 2016-2024 Copyright www.sucross.com