Subaru Crosstrek Service Manual: Hill start assist warning light does not come on
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination Pattern
HILL START ASSIST WARNING LIGHT DOES NOT COME ON
Detecting condition:
Defective combination meter
Trouble symptom:
When the ignition switch is turned to ON (engine OFF), hill start assist warning light does not illuminate.
| STEP | CHECK | YES | NO |
1.CHECK OTHER INDICATOR LIGHT.
Turn the ignition switch to ON. (Engine OFF)
Do other indicator lights illuminate?
Warning Light Illumination Pattern > HILL START ASSIST WARNING LIGHT DOES NOT COME ON">Go to Step 2.
Check the combination meter. Combination Meter System > OPERATION">
2.READ DTC.
Read the DTC. Read Diagnostic Trouble Code (DTC)">
Is DTC displayed?
Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">
Warning Light Illumination Pattern > HILL START ASSIST WARNING LIGHT DOES NOT COME ON">Go to Step 3.
3.CHECK LAN SYSTEM.
Perform the diagnosis for LAN system. Basic Diagnostic Procedure">
Is there any fault in LAN system?
Perform the diagnosis according to DTC for LAN system. List of Diagnostic Trouble Code (DTC)">
Warning Light Illumination Pattern > HILL START ASSIST WARNING LIGHT DOES NOT COME ON">Go to Step 4.
4.CHECK COMBINATION METER.
Check the combination meter. Combination Meter System > OPERATION">
Is the check result OK?
• Models without EyeSight
Replace the VDCCM only. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > REPLACEMENT">
• Models with EyeSight
Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">
Replace the combination meter. Combination Meter">
Brake warning light does not go off
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternBRAKE WARNING LIGHT DOES NOT GO OFFDetecting condition:• Brake warning light circuit is shorted.• Defect ...
Basic diagnostic procedure Procedure
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:Remove foreign matter (dust, water, oil etc.) from the VDCCM&H/U connector during removal and installat ...
Other materials:
Inspection
COOLING(H4DO) > ThermostatINSPECTION1. Check that the thermostat does not have deformation, cracks or damage.2. Check that the thermostat valve closes completely at an ambient temperature.3. Immerse the thermostat and a thermometer in water. Raise water temperature gradually, and check the temper ...
Preparation tool
SEATS > General DescriptionPREPARATION TOOL1. GENERAL TOOLTOOL NAMEREMARKSLong nose pliersUsed for removing the hog ring.Hog ring pliersUsed for installing the hog ring.Circuit testerUsed for measuring resistance, voltage and current. ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Automatic Transmission AssemblyINSTALLATION1. Attach the ST to converter case.ST 498277200STOPPER SET2. When completely overhauling the transmission, refill CVTF through the transmission right side plug. Preparation for Overhaul">3. Replace ...
