Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: High/low beam change (dimmer)

High/low beam change (dimmer)

To change from low beam to high beam, push the turn signal lever forward. When the headlights are on high beam, the high beam indicator light "  " on the combination meter is also on.

To switch back to low beam, pull the lever back to the center position.

Sensor for the auto on/off headlights (if equipped)
The sensor is on the instrument panel as shown in the illustration. CAUTION If any object is placed on or near the sensor, the sensor may not detect the level of the ambient light correctly ...

Headlight flasher
CAUTION Do not hold the lever in the flashing position for more than just a few seconds. To flash the headlights, pull the lever toward you and then release it. The high beam will stay on fo ...

Other materials:

Headlight beam leveler
The Subaru Ascent is equipped with high-performance LED headlights, which provide significantly greater illumination compared to traditional halogen systems. When carrying heavy loads, the angle of the headlights may shift upward, potentially causing glare for oncoming drivers. To counteract th ...

Inspection mode Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Inspection ModeOPERATIONIt is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is r ...

Disposal
REAR SUSPENSION > Rear Shock AbsorberDISPOSALCAUTION:• Before discarding the strut COMPL and the shock absorber COMPL, be sure to wear goggles to protect eyes from gas, oil and cutting powder.• Do not disassemble the strut COMPL and the shock absorber COMPL or throw them into flames.& ...

© 2016-2026 Copyright www.sucross.com