Subaru Crosstrek Owners Manual: Headlights
To turn on the headlights, turn the knob on the end of the turn signal lever.
"
" position
Instrument panel illumination, headlights, parking lights, front side marker lights, rear side marker lights, tail lights and license plate lights are on.
"
" position
Instrument panel illumination, parking lights, front side marker lights, rear side marker lights, tail lights and license plate lights are on.
" 
" position: auto on/off
headlights (if
equipped)
When the ignition switch is in the "ON" position, the instrument panel illumination, headlights, parking lights, front side marker lights, rear side marker lights, tail lights and license plate lights are automatically on or off depending on the level of the ambient light.
" 
" position
The headlights are all off.
NOTE
The sensitivity of the auto on/off headlights can be changed by a SUBARU dealer. Consult your SUBARU dealer for details. Also, for models with a multi function display, the setting can be changed using the display. For details, refer to "Auto light sensor sensitivity setting"
Light control switch
CAUTION
Use of any lights for a long period
of time while the engine is not
running can cause the battery to
discharge.
Before leaving the vehicle, make
sure that the lights are turned o ...
Welcome lighting function (if
equipped)
The welcome lighting function turns on the
low beam headlight for smooth approaching
to or exiting from the vehicle at night or
in a dark place.
The function is activated while all of the
follo ...
Other materials:
Inspection
VEHICLE DYNAMICS CONTROL (VDC) > Yaw Rate and G SensorINSPECTION1. YAW RATE & LONGITUDINAL G AND LATERAL G SENSOR SIGNALSTEPCHECKYESNO1.CHECK YAW RATE & G SENSOR.1) Check the installation condition of the VDC control module & hydraulic control module (VDCCM&H/U).2) Using the Subar ...
Dtc b2788 ign signal correlation (steering lock cm)
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2788 IGN SIGNAL CORRELATION (STEERING LOCK CM)DTC detecting condition:When mismatch occurs in the IG1 input of the steering lock CM for both LIN communication line input (IG1 i ...
Inspection
STARTING/CHARGING SYSTEMS(H4DO) > StarterINSPECTIONNOTE:• After the inspection, reinstall the disassembled or removed parts during the inspection in the reverse order of disassembly/removal procedure.• Refer to component for tightening torque of each part. General Description > CO ...
