
CAUTION
Do not hold the lever in the flashing position for more than just a few seconds.
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
the lever. The headlight flasher works
even though the lighting switch is in the
"
" (off) position.
When the headlights are on high beam,
the high beam indicator light "
"
on the
combination meter also illuminates.
High/low beam change (dimmer)
Daytime running light systemDtc p0961 pressure control solenoid "a" control circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0961 PRESSURE CONTROL SOLENOID "A" CONTROL CIRCUIT RANGE/PERFORMANCEDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Acceleration is poor during ...
Assembly
REAR SUSPENSION > Rear Lateral LinkASSEMBLY1. Before assembly, inspect the following items and replace any faulty part with a new one.• Visually check the lateral link assembly - rear for damage and deformation.• Visually check the bushing for abnormal cracks, fatigue or damage.2. Usi ...
ABS (Anti-lock Brake System)
The ABS system in the Subaru Ascent is engineered to prevent wheel lock-up during
sudden or emergency braking, especially on slippery or uneven road surfaces. By
maintaining wheel rotation, the system allows the driver to retain steering control
and directional stability, reducing the risk of ...