Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Head restraint angle adjustment

Head restraint angle adjustment

The angle of the head restraint can be adjusted in several steps. While maintaining a suitable driving posture, adjust the head restraint to a position where the back of your head is as close to the head restraint as possible.

To tilt: Tilt the head restraint by hand to the preferred position. A click will be audible when the head restraint is locked.

To return: Tilt the head restraint once as far forward as it can go. The head restraint will automatically return to the fully upright position. Then, adjust the head restraint again to the preferred angle.

Head restraint height adjustment
Head restraint Release button To raise: Pull the head restraint up. To lower: Push the head restraint down while pressing the release button on the top of the seatback. To remove ...

Seat heater (if equipped)
The seat heater is equipped in the front seats. The seat heater operates when the ignition switch is either in the "ACC" or "ON" position. ...

Other materials:

Maximum load limits
WARNING Never exceed the maximum load limits explained in the following. Exceeding the maximum load limits could cause personal injury and/or vehicle damage. CAUTION Adequate size trailer brakes are required when the trailer and its cargo exceed 1,000 lbs (453 kg) total weight. B ...

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyINSTALLATION1. Attach the needle bearing and oil seal to the front of the main shaft assembly.NOTE:• Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.• Apply NICHIMOLY N-130 or the equivale ...

Inspection
DRIVE SHAFT SYSTEM > Propeller ShaftINSPECTIONCheck the propeller shaft with the propeller shaft installed to the vehicle.1. Remove the front exhaust pipe. Front Exhaust Pipe > REMOVAL">2. Remove the center exhaust pipe, rear exhaust pipe, and muffler.• Center exhaust pipe & ...

© 2016-2025 Copyright www.sucross.com