Subaru Crosstrek Owners Manual: Handling of radar sensors

Subaru Crosstrek Owners Manual / Starting and operating / BSD/RCTA (if equipped) / Handling of radar sensors

Radar sensors

The radar sensors, one on each side of the vehicle, are mounted inside the rear bumper.

Handling of radar sensors

CAUTION

To ensure correct operation of the BSD/RCTA, observe the following precautions.

Always keep the bumper surface near the radar sensors clean
Do not affix any stickers or other items on the bumper surface near the radar sensors. For details, consult your SUBARU dealer.
Do not modify the bumper near the radar sensors.
Do not paint the bumper near the radar sensors.
Do not expose the bumper near the radar sensors to strong impacts.

If a sensor becomes misaligned, a system malfunction may occur, including the inability to detect vehicles entering the detection areas. If any strong shock is applied to the bumper, be sure to contact your SUBARU dealer for inspection.
Do not disassemble the radar sensors.

NOTE

If the radar sensors require repair or replacement, or the bumper area around the radar sensors requires repair, paintwork or replacement, contact your SUBARU dealer for assistance.

Certification for the BSD/RCTA

U.S.-spec. models: FCC ID: OAYSRR2A CAUTION FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the e ...

Driving tips

...

Other materials:

Leather seat materials
The leather used by SUBARU is a high quality natural product which will retain its distinctive appearance and feel for many years with proper care. Allowing dust or road dirt to build up on the surface can cause the material to become brittle and to wear prematurely. Regular cleaning with a ...

Assembly
DRIVE SHAFT SYSTEM > Rear AxleASSEMBLY1. BUSHING - REAR AXLE HOUSINGDo not remove the bushing - rear axle housing from the rear axle housing, because it cannot be replaced. If removed, replace the rear axle housing.2. REAR BUSHING1. Before assembly, inspect the following items and replace any fau ...

Removal
ENTERTAINMENT > Rear Accessory Power Supply SocketREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the console box assembly. Console Box > REMOVAL">3. Remove the socket assembly.(1) While releasing the c ...