FRONT SUSPENSION > General Diagnostic Table
INSPECTION
1. IMPROPER VEHICLE POSTURE OR IMPROPER WHEEL ARCH HEIGHT
Possible cause | Corrective action |
(1) Permanent distortion or damage of the coil spring | Replace. |
(2) Rough operation of strut or shock absorber | Replace. |
(3) Improper installation of strut or shock absorber | Replace with appropriate parts. |
(4) Installation of the wrong coil spring | Replace with appropriate parts. |
2. POOR RIDE COMFORT
1. Large rebound shock
2. Rocking of the vehicle continues too long after running over bump and hump.
3. Excessive shock in bumping
Possible cause | Corrective action |
(1) Damaged coil spring | Replace. |
(2) Overinflation of tires | Adjust. |
(3) Improper wheel arch height | Replace the coil springs with new parts. |
(4) Fault in operation of strut or shock absorber | Replace. |
(5) Damage or deformation of strut mount or shock absorber mount | Replace. |
(6) Unsuitable length (maximum or minimum) of strut or shock absorber | Replace with appropriate parts. |
(7) Abnormal deformation or loss of bushing | Replace. |
(8) Deformation or damage of helper in strut assembly or shock absorber | Replace. |
(9) Oil leakage from the strut or shock absorber | Replace. |
3. NOISE
Possible cause | Corrective action |
(1) Wear or damage of strut or shock absorber component parts | Replace. |
(2) Loosening of the suspension link installing bolt | Tighten to the specified torque. |
(3) Abnormal deformation or loss of bushing | Replace. |
(4) Unsuitable length (maximum or minimum) of strut or shock absorber | Replace with appropriate parts. |
(5) Damaged coil spring | Replace. |
(6) Wear or damage of the ball joint | Replace. |
(7) Deformation of the clamp - stabilizer bushing | Replace. |
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Center DifferentialASSEMBLYInstall the ball bearings.CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Use a new ball bearing.(A)Ball bearing ...
Dtc p1449 evap system clog detected (air filter)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1449 EVAP SYSTEM CLOG DETECTED (AIR FILTER)DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode C ...
Dtc b14e1 air mix door actuator stepping motor circuit open (driver)
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E1 AIR MIX DOOR ACTUATOR STEPPING MOTOR CIRCUIT OPEN (DRIVER)DTC detecting condition:Air mix door actuator stepping motor circuit is open.Trouble symptom:Temperature cannot be adjusted.Wiring diag ...