Subaru Crosstrek Service Manual: General diagnostic table Inspection
DRIVE SHAFT SYSTEM > General Diagnostic Table
INSPECTION
NOTE:
Vibration while cruising may be caused by an unbalanced tire, improper tire inflation pressure, improper wheel alignment, etc.
Symptoms | Possible cause | Corrective action |
Noise or vibration from propeller shaft |
• Center bearing
• Runout of propeller shaft
• Loose or gap at connections
Inspect the propeller shaft. Propeller Shaft > INSPECTION">
Abnormal wheel vibration
Wheel is out of balance.
Check the wheel balance. Tire and Wheel > INSPECTION">
Front wheel alignment
Check the front wheel alignment. Wheel Alignment > INSPECTION">
Rear wheel alignment
Check the rear wheel alignment. Wheel Alignment > INSPECTION">
Front strut
Check the front strut. Front Strut > INSPECTION">
Rear shock absorber
Check the rear shock absorber. Rear Shock Absorber > INSPECTION">
Front drive shaft
Check the front drive shaft. Front Drive Shaft > INSPECTION">
Rear drive shaft
Check the rear drive shaft. Rear Drive Shaft > INSPECTION">
Front hub unit bearing
Check the front hub unit bearing. Front Hub Unit Bearing > INSPECTION">
Rear hub unit bearing
Check the rear hub unit bearing. Rear Hub Unit Bearing > INSPECTION">
Noise from the underbody
Wheel is out of balance.
Check the wheel balance. Tire and Wheel > INSPECTION">
Front wheel alignment
Check the front wheel alignment. Wheel Alignment > INSPECTION">
Rear wheel alignment
Check the rear wheel alignment. Wheel Alignment > INSPECTION">
Front strut
Check the front strut. Front Strut > INSPECTION">
Rear shock absorber
Check the rear shock absorber. Rear Shock Absorber > INSPECTION">
Installation
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingINSTALLATION1. Place the rear brake back plate between the rear axle housing and the rear hub unit bearing, and tighten the bolt.CAUTION:• Be careful ...
Other materials:
Disposal
REAR SUSPENSION > Rear Shock AbsorberDISPOSALCAUTION:• Before discarding the strut COMPL and the shock absorber COMPL, be sure to wear goggles to protect eyes from gas, oil and cutting powder.• Do not disassemble the strut COMPL and the shock absorber COMPL or throw them into flames.& ...
Assembly
MECHANICAL(H4DO) > Cylinder BlockASSEMBLY1. CYLINDER BLOCK1. Apply liquid gasket to the threaded portion of the main gallery plug, and install the main gallery plug to the cylinder block LH.NOTE:Before applying liquid gasket, degrease the thread holes of the cylinder block LH and main gallery plu ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Turbine Speed SensorREMOVALCAUTION:Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, replace with a new part.1. Lift up the vehicle.2. Remove the harness connector from turbine speed sens ...
