Subaru Crosstrek Service Manual: General diagnostic table Inspection
CONTROL SYSTEMS > General Diagnostic Table
INSPECTION
Symptoms | Possible cause | Corrective action |
Select lever | Starter does not run. | Adjust the select cable and inhibitor switch, or inspect the circuit. |
Back-up light does not illuminate. | Adjust the select cable and inhibitor switch, or inspect the circuit. | |
AT shift lock system does not operate normally. | Adjust the select cable and inhibitor switch, or inspect the circuit. | |
Manual mode can not be set. | Inspect the mode switch and select lever, or inspect the circuit. | |
Up-shift is not engaged at manual mode. | Check the shift-up switch and circuit. | |
Down-shift is not engaged at manual mode. | Check the shift-down switch and circuit. |
Body integrated unit Note
CONTROL SYSTEMS > Body Integrated UnitNOTERefer to “Body Integrated Unit” for removal and installation procedure. Body Integrated Unit"> ...
Cooling(h4do)
...
Other materials:
To decrease the speed (by the "RES/SET" switch)
Press the "RES/SET" switch to the "SET"
side and hold it until the vehicle reaches
the desired speed. Then, release the
switch. The vehicle speed at that moment
will be memorized and treated as the new
set speed.
U.S.-spec. models
When the difference between the actual
vehicle speed and ...
Braking tips
WARNING
Never rest your foot on the brake
pedal while driving. This can cause
dangerous overheating of the
brakes and needless wear on the
brake pads and linings.
When the brakes get wet
When driving in rain or after washing the
vehicle, the brakes may get wet. As a
result, brake stopping d ...
Type C
Airflow mode selection dial (Refer to
"Airflow mode selection"
Defroster button (Refer to "Airflow mode
selection"
Rear window defogger button (Refer to
"Defogger and deicer"
Fan speed control dial (Refer to "Fan
speed control"
Air conditioner button (Refer to "Air
condition ...
