Subaru Crosstrek Service Manual: General description

Installation

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Fuel Sub Level SensorINSTALLATIONFor installation procedures, refer to the “FU (H4DO)” section. Fuel Sub Level Sensor > INST ...

Caution

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, an ...

Other materials:

Disassembly
STARTING/CHARGING SYSTEMS(H4DO) > StarterDISASSEMBLYCAUTION:The starter should be placed through a no-load test whenever it has been overhauled.1. Disconnect the cable from the magnet switch assembly.2. Remove the magnet switch assembly from the starter housing assembly.3. Remove screws (A) of th ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control Module (TCM)INSTALLATION1. Install the bracket to the TCM.2. Install the TCM to the bracket.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)3. Install the TCM.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)4. Install ...

Operating range for push-button start system
Antenna Operating range NOTE If the access key is not detected within the operating range of the antennas inside the vehicle, the pushbutton ignition switch and the engine start cannot be operated. Even when the access key is outside the vehicle, if it is placed too close to the ...