Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: General description

Caution

CRUISE CONTROL SYSTEM > General Description

CAUTION

Before disassembling or reassembling parts, always disconnect the battery ground cable from battery. When replacing the audio, control module and other parts provided with memory functions, record the memory contents before disconnecting the battery ground cable. Otherwise, the memory is cleared.

Reassemble the parts in the reverse order of disassembly procedure unless otherwise indicated.

Adjust parts to the given specifications.

Connect the connectors securely during reassembly.

After reassembly, make sure that the each component operates normally.

Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. Using a tester above such circuits may cause malfunction of airbag system. Follow the cautions of “AIRBAG SYSTEM” in this case. General Description > CAUTION">

Be careful not to damage the airbag system wiring harness when servicing electrical parts and switches.

When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform the VDC setting mode. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

Preparation tool

CRUISE CONTROL SYSTEM > General Description

PREPARATION TOOL

TOOL NAME

REMARKS

Circuit tester

Used for measuring resistance, voltage and current.

Wiring diagram
CRUISE CONTROL SYSTEM > Cruise Control SystemWIRING DIAGRAMRefer to “Cruise Control System” in the wiring diagram. Cruise Control System > WIRING DIAGRAM"> ...

Relay and fuse
Inspection CRUISE CONTROL SYSTEM > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check ...

Other materials:

BSD/RCTA OFF switch
BSD/RCTA OFF switch BSD/RCTA OFF indicator If the BSD/RCTA OFF switch is pressed, the BSD/RCTA OFF indicator appears on the multi information display of the combination meter, and the BSD/RCTA is deactivated. Press the switch again to activate the BSD/RCTA. The BSD/RCTA OFF indicat ...

Removal
WIPER AND WASHER SYSTEMS > Washer Tank and MotorREMOVAL1. WASHER TANK1. Open the hood COMPL - front.2. Disconnect the ground cable from battery. NOTE">3. Remove the bumper face - front. Front Bumper > REMOVAL">4. Remove the tank - washer assembly.(1) Remove the clip of the ho ...

Inspection
PERIODIC MAINTENANCE SERVICES > Front & Rear Differential Gear OilINSPECTION1. FRONT DIFFERENTIAL (MT MODEL)Front differential gear oil of MT model lubricates the transmission and differential together. Refer to “Transmission Gear Oil” for inspection procedures. Transmission Gear ...

© 2016-2024 Copyright www.sucross.com