Subaru Crosstrek Service Manual: General description

Wiring diagram

CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Engine Control Module (ECM) I/O SignalWIRING DIAGRAMRefer to “Cruise Control System” in the wiring diagram. Cruise Control System > WIRING DIAG ...

Caution

CRUISE CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionCAUTIONAirbag system wiring harness is routed near the cruise control command switch.CAUTION:• Do not use the electrical test equipmen ...

Other materials:

Assembly
SEATS > Front SeatASSEMBLYCAUTION:• Do not confuse the harness routing of the side airbag harness and the seat belt inner - front harness, etc. Assembling with harnesses improperly routed may cause the harness to get caught and short out.• If the flat mat hook of the frame assembly - ...

Removal
LIGHTING SYSTEM > Day Time Running ResistorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the screw and clips, and turn over the front side of the mud guard - front.4. Remove the resistor assembly - daytime running light.CAUTION:The resistor ma ...

Removal
MECHANICAL(H4DO) > V-beltREMOVALNOTE:When replacing a single part, perform the work with the engine assembly installed to body.1. V-BELT1. When working on the vehicleNOTE:When working on the vehicle, perform the following steps also.(1) Remove the V-belt covers.(2) Remove the air intake duct. Ai ...