Subaru Crosstrek Service Manual: General description

Installation

CONTROL SYSTEMS > AT Shift Lock Solenoid and “P” Range SwitchINSTALLATIONInstall in the reverse order of removal.NOTE:Insert the solenoid unit terminals to the harness connector.(A)Sole ...

Caution

CONTROL SYSTEMS > General DescriptionCAUTION• Wear appropriate work clothing, including a cap, protective goggles and protective shoes when performing any work.• Remove contamination in ...

Other materials:

Dtc p0717 input/turbine shaft speed sensor "a" circuit no signal
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0717 INPUT/TURBINE SHAFT SPEED SENSOR "A" CIRCUIT NO SIGNALDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Standing start problems• Shock ...

List of cancel code List
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > List of Cancel CodeLISTNOTE:• The cancel code is registered even when cancel is performed intentionally by the driver.• Cancel codes are cleared if the ignition switch is turned to OFF.• If a different cancel code is input after a cancel cod ...

Removal
LIGHTING SYSTEM > Day Time Running ResistorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the screw and clips, and turn over the front side of the mud guard - front.4. Remove the resistor assembly - daytime running light.CAUTION:The resistor ma ...