Subaru Crosstrek Owners Manual: Fuses
CAUTION
Never replace a fuse with one having a higher rating or with material other than a fuse because serious damage or a fire could result.
The fuses are designed to melt during an overload to prevent damage to the wiring harness and electrical equipment. The fuses are located in two fuse boxes.
One is located under the instrument panel behind the fuse box cover on the driver's seat side. To remove the cover, pull it out.
1) Spare fuses
The other one (main fuse box) is housed in the engine compartment. Also, the spare fuses are stored in the fuse box cover.
The fuse puller is stored in the main fuse box in the engine compartment.
- Good
- Blown
If any lights, accessories or other electrical controls do not operate, inspect the corresponding fuse. If a fuse has blown, replace it.
1. Turn the ignition switch to the "LOCK"/ "OFF" position and turn off all electrical accessories.
2. Remove the cover.
3. Determine which fuse may be blown.
Look at the back side of each fuse box cover and refer to "Fuses and circuits" F12-9.
4. Pull out the fuse with the fuse puller.
5. Inspect the fuse. If it has blown, replace it with a spare fuse of the same rating.
6. If the same fuse blows again, this indicates that its system has a problem.
Contact your SUBARU dealer for repairs.
Battery
WARNING
Before beginning work on or near
any battery, be sure to extinguish
all cigarettes, matches, and lighters.
Never expose a battery to an
open flame or electric sparks.
Batteri ...
Installation of accessories
Always consult your SUBARU dealer
before installing fog lights or any other
electrical equipment in your vehicle. Such
accessories may cause the electronic
system to malfunction if they are incorr ...
Other materials:
Brake system warning light (red)
The
light illuminates with the parking
brake applied while the ignition switch is
in the "ON" position. It turns off when the
parking brake is fully released.
WARNING
Driving with the brake system
warning light on is dangerous.
This indicates your brake system
may not be working ...
Dome light
ON
DOOR
OFF
The dome light switch has the following
positions.
ON: The light remains on continuously.
OFF: The light remains off.
DOOR: The dome light illuminates automatically
in the following cases.
Any of the doors or the rear gate is
opened.
The doors or the rear g ...
Procedure
LAN SYSTEM (DIAGNOSTICS) > CAN Communication Circuit CheckPROCEDURENOTE:• When measuring the resistance of CAN communication circuit, measure it in sleep status.To enter sleep status– With ignition switch OFF and key or switch operation stopped, keep the doors, trunk, and rear gate all c ...
