BODY CONTROL SYSTEM (DIAGNOSTICS) > Function Check
OPERATION
NOTE:
In order to check the body integrated unit function, inspect the body integrated unit and actuator using Subaru Select Monitor without operating switches.
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Body Control» and then select «Enter».
5. On «Select Function» display, select «Active Test».
NOTE:
• If not equipped (depending on destination area or vehicle equipment condition), process will not go on.
• The operation is disabled for the models with keyless access with push button start system because the key lock solenoid is not installed.
• For detailed operation procedures, refer to “Application help”.
Basic diagnostic procedure Procedure
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.CHECK WARNING LIGHT.Check whether the airbag warning light in the combination meter is lit.Does the airbag warning light illuminate? Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.Perform ...
Preparation for overhaul Procedure
MECHANICAL(H4DO) > Preparation for OverhaulPROCEDURE1. After removing the engine from the vehicle body, attach the ST to the engine as shown in the figure.NOTE:When using a commercially sold engine stand, follow the instructions of engine stand used.Tightening torque:35 N·m (3.6 kgf-m, 25. ...
Operation
EyeSight (DIAGNOSTICS) > Diagnostic Code(s) DisplayOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, select ...