Subaru Crosstrek Service Manual: Fuel sub level sensor

Installation

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Fuel Level SensorINSTALLATIONFor installation procedures, refer to the “FU (H4DO)” section. Fuel Level Sensor > INSTALLATION ...

Inspection

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Fuel Sub Level SensorINSPECTIONFor inspection procedures, refer to the “FU (H4DO)” section. Fuel Sub Level Sensor > INSPECTI ...

Other materials:

Assembly
DRIVE SHAFT SYSTEM > Rear AxleASSEMBLY1. BUSHING - REAR AXLE HOUSINGDo not remove the bushing - rear axle housing from the rear axle housing, because it cannot be replaced. If removed, replace the rear axle housing.2. REAR BUSHING1. Before assembly, inspect the following items and replace any fau ...

Auto light sensor sensitivity setting
1. Perform the preparation steps according to "Preparation for car settings" 2. Operate the " " or " " switch to select the "Auto Light Sensor" item. Then push the   button. 3. The current setting will be displayed. Push the button to enter the selection mode. 4. Selec ...

Trailer Hitches
WARNING Under no circumstances should you drill into the frame or underbody of your Subaru Ascent to install an aftermarket or commercial trailer hitch. Such actions may allow harmful substances such as exhaust gases, water, or road debris to penetrate the passenger compartment through the c ...