Subaru Crosstrek Service Manual: Fuel pressure Inspection

1. Release the fuel pressure. Fuel > PROCEDURE">

2. Open the fuel filler lid and remove the fuel filler cap.

NOTE:

This operation is required to release the inner pressure of the fuel tank.

3. Disconnect the fuel delivery tube from the fuel delivery pipe, and connect the fuel pressure gauge.

CAUTION:

• Be careful not to spill fuel.

• Catch the fuel from the tubes using a container or cloth.

(1) Disconnect the quick connector on the fuel delivery tube from the fuel pipe assembly, and remove the clip (A) securing the fuel delivery tube to the fuel pipe assembly.

NOTE:

Disconnect the quick connector as shown in the figure.

(2) Connect the fuel pressure gauge with ST1 and ST2.

CAUTION:

• Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.

• When connecting the quick connector with slider, make sure to insert it all the way in before locking the slider.

• When it is difficult to lock the slider, check that the connector is fully inserted.

• After locking the slider, check that the quick connector is securely connected.

• ST1 is a SUBARU genuine part.

• When connecting the ST2 to the quick connector on the fuel delivery tube, connect as shown in the figure.

4. Start the engine.

5. Check the fuel pressure after warming up the engine.

NOTE:

• The fuel pressure gauge registers 10 to 20 kPa (0.1 to 0.2 kg/cm2, 1 to 3 psi) higher than standard values during high-altitude operations.

• Check or replace the fuel pump and fuel delivery line if the fuel pressure is out of the standard.

Fuel pressure:

Standard

340 — 400 kPa (3.5 — 4.1 kg/cm2, 49 — 58 psi)

6. After inspection, install the related parts in the reverse order of removal.

CAUTION:

• Before removing the fuel pressure gauge, release the fuel pressure.

• Be careful not to spill fuel.

• Catch the fuel from hoses and tubes using a container or cloth.

• Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.

• When connecting the quick connector with slider, make sure to insert it all the way in before locking the slider.

• When it is difficult to lock the slider, check that the connector is fully inserted.

• After locking the slider, check that the quick connector is securely connected.

• When disconnecting the ST1, install the ST2 to the fuel pipe assembly, and press the ST2 in the direction of arrow to disconnect the quick connector on the ST1.

Engine trouble in general Inspection

Idle speed Inspection

Other materials:

Dtc c2123 transmitter 3 no data
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2123 TRANSMITTER 3 NO DATANOTE:Refer to DTC C2124 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2124 TRANSMITTER 4 NO DATA"> ...

Caution
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > General DescriptionCAUTION1. Never connect the battery in reverse polarity.• Doing so may immediately damage the A/C control panel.2. Do not disconnect the battery cables while the engine is running.• A large counter electromotive force will be g ...

Inspection
SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator AssemblyINSPECTION1. LATCHCheck if the latch operates normally.If the cable or rod is faulty, replace the latch & actuator assembly - front.2. LOCK ACTUATORPreparation tool:Circuit tester1. Check door lock operationCheck the door lo ...