Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Fuel filler lid and cap

Locations of the fuel filler lid and the lid release lever

Fuel filler lid
Fuel filler lid

Fuel filler lid release lever
Fuel filler lid release lever

Refueling

Only one person should be involved in refueling. Do not allow others to approach the area of the vehicle near the fuel filler pipe while refueling is in progress.

Be sure to observe any other precautions that are posted at the service station.

1. Stop the vehicle and turn the ignition switch to the "LOCK"/"OFF" position and turn off all the other electrical components.

2. To open the fuel filler lid, pull the lid release lever up. The lever is on the floor at the left of the driver's seat.

WARNING

Before opening the fuel filler cap, first touch the vehicle body or a metal portion of the fuel pump or similar object to discharge any static electricity that may be present on your body. If your body is carrying an electrostatic charge, there is a possibility that an electric spark could ignite the fuel, which could burn you. To avoid acquiring a new static electric charge, do not get back into the vehicle while refueling is in progress.

Refueling

  1. Open
  2. Close

3. Remove the fuel filler cap by turning it slowly counterclockwise.

WARNING

Refueling

4. Set the fuel filler cap on the cap holder inside the fuel filler lid.

WARNING

5. Stop filling the tank after the fuel filler pump automatically stops. Do not add any more fuel.

6. Put the cap back on, turn it clockwise until you hear a clicking noise. Be certain not to catch the tether under the cap while tightening.

CAUTION

Make sure that the cap is tightened until it clicks to prevent fuel spillage in the event of an accident.

7. Close the fuel filler lid completely.

CAUTION

If you spill any fuel on the painted surface, rinse it off immediately.

Otherwise, the painted surface could be damaged.

NOTE

CAUTION

Gasoline for cleaner air
Your use of gasoline with detergent additives will help prevent deposits from forming in your engine and fuel system. This helps keep your engine in tune and your emission control system working ...

State emission testing (U.S. only)
WARNING Testing of an All-Wheel Drive model must NEVER be performed on a single two-wheel dynamometer. Attempting to do so will result in uncontrolled vehicle movement and may cause an accident ...

Other materials:

Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Shifter Fork and RodINSPECTION1. Check the shifter fork and fork rod for damage. Replace if it is damaged.2. Gearshift mechanismRepair or replace the gearshift mechanism if excessively worn, bent or defective in any way.3. Inspect the clearance between ...

Dtc b1406 scu_eeprom
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1406 SCU_EEPROMDTC DETECTING CONDITION:• Defective security control module• ROM of security control module cannot be accessedCAUTION:When the security control module is replaced, registration of th ...

How to use the rear view camera
When the shift lever/select lever is set to "R", the rear view camera automatically displays the rear view image from the vehicle. When the lever is set to other positions, the image before setting to "R" is displayed. 1. Set the ignition switch to "ON". 2. Set the shift lever/select leve ...

© 2016-2024 Copyright www.sucross.com