Subaru Crosstrek Service Manual: Front sub sensor

Removal

AIRBAG SYSTEM > Front Door Impact SensorREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM&rdqu ...

Installation

AIRBAG SYSTEM > Front Sub SensorINSTALLATIONCAUTION:• If the airbag has been activated, replace the front sub sensor with a new part.• Do not reuse the bolt and nut.Always replace with ...

Other materials:

Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearASSEMBLY1. Set the ST against the inner race of the ball bearing, and install the transfer drive gear.CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Use a new ball bearing.ST 398177700INSTALLER ...

Operating conditions
The Reverse Automatic Braking (RAB) system in the Subaru Ascent is engineered to function only when a specific set of operating conditions is satisfied. These requirements ensure that the system delivers accurate detection and reliable braking assistance while reversing. EyeSight warni ...

Rear combination lights
1. Using a Phillips screwdriver, remove the upper and lower screws that secure the rear combination light assembly. 2. Slide the rear combination light as- 11-38 sembly rearward and remove it from the vehicle. Rear side marker light Rear turn signal light Backup light Sto ...