Subaru Crosstrek Service Manual: Front magnetic encoder

Subaru Crosstrek Service Manual / Vehicle dynamics control (vdc) / Front magnetic encoder

Installation

VEHICLE DYNAMICS CONTROL (VDC) > Front ABS Wheel Speed SensorINSTALLATIONCAUTION:• Be careful not to damage the sensor.• Do not apply excessive force to the sensor harness.Install each ...

VEHICLE DYNAMICS CONTROL (VDC) > Front Magnetic EncoderINSPECTIONVisually check the magnetic encoder for any damage. If necessary, replace with a new hub unit COMPL - front axle.NOTE:Because the ma ...

Other materials:

Engine low oil level warning light
This light illuminates when the engine oil level decreases to the lower limit. If the engine low oil level warning light illuminates while driving, park the vehicle in a safe and level location, and then check the engine oil level. When the engine oil level is not within the normal rang ...

Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting FailurePROCEDURE1. Check of the fuel amount↓2. Inspection of starter motor circuit Diagnostics for Engine Starting Failure > STARTER MOTOR CIRCUIT">↓3. Inspection of ECM power supply and ground line Diagnostics fo ...

Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearASSEMBLY1. Set the ST against the inner race of the ball bearing, and install the transfer drive gear.CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Use a new ball bearing.ST 398177700INSTALLER ...