Subaru Crosstrek Service Manual: Front hub unit bearing

Installation

DRIVE SHAFT SYSTEM > Front Drive ShaftINSTALLATION1. Before installation, check the drive shaft assembly. Front Drive Shaft > INSPECTION">2. Replace the differential side retainer oil s ...

Assembly

DRIVE SHAFT SYSTEM > Front Hub Unit BearingASSEMBLY1. Install the hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)2. Using a press, press the new hub bolts (b) until t ...

Other materials:

U.S.-spec. models (type B)
The illustration above is a typical example. For some models, the combination meter may be slightly different than that shown in the illustration. Tachometer Multi information display Fuel gauge Select lever/gear position indicator Speedometer Information display selection knob ...

Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Purge Control Solenoid ValveREMOVAL1. Disconnect the ground cable from battery.2. Remove the bolt which holds the purge control solenoid valve onto intake manifold.NOTE:Hold the purge control solenoid valve unit by hand to prevent it from r ...

Electrical specification
SECURITY AND LOCKS > Keyless Entry SystemELECTRICAL SPECIFICATION1. KEYLESS ENTRY CONTROL MODULE• Model without tire pressure monitoring systemTerminal No.ItemMeasuring conditionStandard3 (U-ART com.) — Cannot be measured — 4 (+B) ←> Chassis groundVoltageAlways10 — 14 V7 (GND) ...