Subaru Crosstrek Owners Manual: Forward and backward adjustment
Pull the lever upward and slide the seat to the desired position. Then release the lever and try to move the seat back and forth to make sure that it is securely locked into place.
Front seats
WARNING
Never adjust the seat while driving
to avoid loss of vehicle control
and personal injury.
Before adjusting the seat, make
sure the hands and feet of rear
seat passengers and carg ...
Reclining the seatback
Pull the reclining lever up and adjust the
seatback to the desired position. Then
release the lever and make sure the
seatback is securely locked into place.
The seatback placed in a recline ...
Other materials:
General diagnostic table Inspection
DRIVE SHAFT SYSTEM > General Diagnostic TableINSPECTIONNOTE:Vibration while cruising may be caused by an unbalanced tire, improper tire inflation pressure, improper wheel alignment, etc.SymptomsPossible causeCorrective actionNoise or vibration from propeller shaft• Center bearing• Run ...
Refrigerant leak check Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Leak CheckINSPECTION1. Attach the manifold gauge set.Preparation tool:Manifold gauge set(1) Check that all valves are fully closed.(2) Install the low/high pressure hoses to the service ports on the low/high pressure sides of the vehicle resp ...
Dtc u0122 lost communication with vehicle dynamics control module
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULEDetected when CAN data (vehicle speed signal) is not received from VDC.NOTE:Perform the diagnosis for LAN system. Basic Diagn ...
