Subaru Crosstrek Service Manual: Forced drive
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Glass Lid
FORCED DRIVE
If the lid assembly - sunroof does not operate or the motor assembly is not supplied with power, move the lid assembly - sunroof using the hexagon wrench.
Preparation tool:
Hexagon wrench: width across flat 4 mm (0.16 in)
CAUTION:
After a forced operation, make sure to perform an initialize operation. Sunroof Control System > OPERATION">
1. Disconnect the ground cable from battery. NOTE">
2. Remove the light assembly - map. Spot Map Light > REMOVAL">
3. Remove the stereo camera cover assembly. (Models with EyeSight) Stereo Camera > REMOVAL">
4. Insert the hexagon wrench securely until it touches the motor shaft end.
5. Turn the hexagon wrench, and move the lid assembly - sunroof.
• Turning right, the lid assembly - sunroof opens.
• Turning left, the lid assembly - sunroof closes.
CAUTION:
Be careful not to damage the adjacent parts with the rod end when moving the lid assembly - sunroof with the hexagon wrench.
Adjustment
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Glass LidADJUSTMENT1. Adjust the height of the lid assembly - sunroof and the roof panel.2. Loosen the lid assembly - sunroof mounting bolts (A), and then ...
Installation
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Glass LidINSTALLATION1. GLASS LID1. Using a new TORX® bolt, install the lid assembly - sunroof.Tightening torque:4.5 N·m (0.46 kgf-m, 3.3 ft-lb)2. ...
Other materials:
Specification
WIPER AND WASHER SYSTEMS > General DescriptionSPECIFICATIONFront wiper motorInput12 V — 72 W or lessRear wiper motorInput12 V — 42 W or lessFront washer motorPump typeCentrifugalInput12 V — 60 W or lessRear washer motorPump typeCentrifugalInput12 V — 36 W or less ...
Removal
POWER ASSISTED SYSTEM (POWER STEERING) > Steering ColumnREMOVALCAUTION:Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Pump RelayREMOVAL1. Disconnect the ground cable from battery.2. Remove the glove box. Glove Box > REMOVAL">3. Remove the fuel pump relay from relay block. ...
