Subaru Crosstrek Service Manual: Flywheel

Installation

CLUTCH SYSTEM > Clutch SwitchINSTALLATION1. CLUTCH SWITCH1. Install the clutch switch.2. Move the clevis pin of push rod to left and right, retain it at the position where it moves smoothly, and me ...

Inspection

CLUTCH SYSTEM > FlywheelINSPECTIONCAUTION:Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.1. If there is damage or defectivene ...

Other materials:

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSTALLATION1. Install the knock sensor to the cylinder block.NOTE:The knock sensor should be installed so that the center of the connector is positioned at a 76.5 — 91.5° angle relative to the front of engine.Tightening torque:24 N&m ...

Tire pressure monitoring system (TPMS) (U.S.-spec. models)
Low tire pressure warning light (type A) Low tire pressure warning light (type B) The tire pressure monitoring system provides the driver with the warning message indicated by sending a signal from a sensor that is installed in each wheel when tire pressure is severely low. The tire ...

Disassembly
FRONT SUSPENSION > Front StrutDISASSEMBLY1. Using a coil spring compressor, compress the coil spring - front.2. Using a hexagon wrench to prevent strut rod from turning, remove the self-locking nut with ST.CAUTION:When installing the coil spring compressor to the coil spring, follow the operation ...