Subaru Crosstrek Service Manual: Extension case oil seal

Installation

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension CaseINSTALLATION1. Clean the mating surface of extension case and transmission case.2. Select the transfer drive gear shim. Reduction Drive Ge ...

Inspection

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension Case Oil SealINSPECTIONCheck for leakage of CVTF from the joint section of transmission and propeller shaft. If a leak is found, inspect the pr ...

Other materials:

Removal
VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)REMOVAL1. MODELS WITHOUT EyeSight1. Disconnect the ground cable from battery. NOTE">2. Remove the air intake boot. Air Intake Boot > REMOVAL">CAUTION:Move aside the intake boot to pe ...

Removal
FRONT SUSPENSION > Front StrutREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the front strut assembly.(1) Place an alignment mark (a) on the adjusting bolt and the strut.(2) Remove the brake hose bracket.(3) Remove the clamp of ABS wheel speed sensor harness.(4) Remove ...

Rear tie-down holes
Rear tie-down hole The rear tie-down holes are located near each of the jack-up reinforcements. There is a plug in each rear tie-down hole. To use the rear tie-down holes, remove the plugs. After using the rear tie-down holes, return the plugs to their original places. WARNING ...